| From | Message |
Peter
Dodge Dakota
JOIN HERE
3/17/2006
13:16:38
|
 Subject: upper control arms???
IP: Logged
Message:
93 4x4 upper control arms have a bolt preventing easy removal . Its located directly behind one of two nuts nedded to loosen in order to adjust the control arm . Is this a factory setting and needs to be romved:ie grind it off ??? Or is there something I`m missing ? . Any help would be great , thanks , Peter
|
chris in SD
Dodge Dakota
JOIN HERE
3/18/2006
00:52:16
|  RE: upper control arms???
IP: Logged
Message:
If its the same set up at my 95 4x4 then you should not have to,
the two bolts on top at the arm, next to the joints are what you
need to get loose to adjust it out, i think.
|
peter
Dodge Dakota
JOIN HERE
3/18/2006
01:59:04
| RE: upper control arms???
IP: Logged
Message:
Thanks Chris , let me better explain . there is no way to get a wrench , socket or anything on this . I`m baffled how it was origially done . Behind one of the adjusting nuts , there is a bolt . The head of the bolt is so tight against the nut I have no way to loosen anything . I can`t see anything this bolt could be attached to as it goes into the chassis . I`ve had over 30 vehicles and do ALL my own work , this isn`t the first time I`ve done a control arm adjustment or replace the bushings . I can say I haven`t come across this before . In GM mid 90`s trucks , there is a pin that had to be removed and I was thinking this is the same . What is this bolt????
|
Chris in SD
Dodge Dakota
JOIN HERE
3/19/2006
01:16:28
| RE: upper control arms???
IP: Logged
Message:
ok well sry i cant help, ive have had it explained to me before but i
dont total understad it, but ya. well if you figure it out let me know
if i run into that problem.that would be good to know info,
Thanks
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
