| From | Message |
luke
Dodge Dakota
JOIN HERE
10/15/2005
08:54:09
|
 Subject: engine fan
IP: Logged
Message:
anybody know's how in the h... do we take that da#@$% engine fan out of there . look like there is only one big nut that hold everything in place and how dose that pulley hold afterwords???
|
Rob C
Dodge Dakota
JOIN HERE
10/15/2005
14:23:35
|  RE: engine fan
IP: Logged
Message:
That big nut holds on the clutch fan only, the pulley is pressed onto the water pump. It's not going to fall off if you remove the clutch fan.
|
Sneezer
Dodge Dakota
JOIN HERE
10/17/2005
13:00:21
| RE: engine fan
IP: Logged
Message:
I use an adjustable pipe wrench from the vise-grip people. I had it in my garage to work on my sprinkler system, but it works fine for me. It will grip the bolt, then you just need to keep the pulley from moving while you break the bolt free. On mine the pulley is bolted on, so I just used a big screwdriver and wedged it between the bolts and off it went.
|
Rob C
Dodge Dakota
JOIN HERE
10/17/2005
20:48:56
|  RE: engine fan
IP: Logged
Message:
I put a big adjustable wrench on the clutch fan and smacked it CCW with a rubber mallet, broke loose on the first try.
I can thank Texas Todd for the procedure.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
