| From | Message |
shlaven
Dodge Dakota
JOIN HERE
10/10/2005
11:10:36
|
 Subject: throttle body spacer
IP: Logged
Message:
is a dodge ram 5.9 throttle body the same size for my 02 5.9 dak. im looking into getting a airaid throttle body spacer and it says applications fit dakotas 94-03 but dosent give motor size, but it does say will fit a dodge ram 5.9. is the bolt pattern the same?
|
Adam
Dodge Dakota
JOIN HERE
10/10/2005
21:06:06
| RE: throttle body spacer
IP: Logged
Message:
Your probably not going to get a response to this because everyone is hellbent against these. Something to do with the beer keg design of the intake. I thought about it until I read around and as far as I have read they've just been known as paper weights. Save your money and get something else. Unless it's free then try it and see what happens. Cant hurt right?
|
daddio
Dodge Dakota
JOIN HERE
10/10/2005
21:12:52
| RE: throttle body spacer
IP: Logged
Message:
adam's right on this one.
|
toolfan
Dodge Dakota
JOIN HERE
10/10/2005
21:37:22
| RE: throttle body spacer
IP: Logged
Message:
i have the helix power tower and was not worth the $90. i would take that money and make a home made cold-air-intake very please with the add preformance of mine. the intake costed me $45. the throttle body spacer does alittle but its is limited because the fuel jets are at the end of the manifold.
|
GraphiteDak
GenIII
10/10/2005
21:41:14
| RE: throttle body spacer
IP: Logged
Message:
Hey there shlaven. You are lucky you received some PLEASANT replies.
There are some who would have flamed you for not searching, etc. :)
Anyway. I agree. SAVE the dough and make a intake tube or something. The 2HP from that will be much more than the TB spacer LOL!
|
galyion
Dodge Dakota
JOIN HERE
10/11/2005
20:54:19
| RE: throttle body spacer
IP: Logged
Message:
are those spacer any good w/ the m1 2brl intake???
|
daddio
Dodge Dakota
JOIN HERE
10/11/2005
21:16:48
| RE: throttle body spacer
IP: Logged
Message:
galyion, i really wouldn't waste the money on one. maybe though if the engine would benefit from a little more plenum volume it may help in the upper rpms, but i doubt it. i know it doesn't benefit the design if the kegger manifold but have read that it may help some on the newer OHV 4.7's & 3.7's. to me it's not worth the money.
|
ScojoDak
Dodge Dakota
JOIN HERE
10/11/2005
22:26:21
| RE: throttle body spacer
IP: Logged
Message:
While the plates alone are a waste of time, money and horsepower, there are great for nitrous nozzles or just a paper weight.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
