| From | Message |
bcrconst
Dodge Dakota
JOIN HERE
6/30/2005
21:45:11
|
 Subject: u joint part #
IP: Logged
Message:
does any one know what the part # is for the u joint@ the rear end on a 1991 4x4 5.2 cc with alum drive shaft. mine went out and i'm gonna have to send some one to napa in the morning while i'm at work to pick one up. always seem to break down when the real part stores are closed!!!! "gee that thing is two different lengths ,never seen that before." - direct quote from autozone emp
cross shafts on joint are two different lengths. yoke on driveshaft is ext retained,internal clips on rearend yoke. any help much apreciated!
|
Sneezer
Dodge Dakota
JOIN HERE
6/30/2005
22:03:06
|  RE: u joint part #
IP: Logged
Message:
Not certain myself, but the Autozone online catalog lists the same part number for both lengths. I tried Napa but their site appears to be down. Might also check Rockauto.com, O'Reilly's and Advance Auto Parts.
Hope this helps. Good luck.
|
bcrconst
Dodge Dakota
JOIN HERE
6/30/2005
23:16:06
| RE: u joint part #
IP: Logged
Message:
thanks i checked the napa cat earlier they list one i think might be what i need but it says for a '3 joint shaft'. do some daks have mid shaft bearings?
thanks but no thanks for the suggestion but orieleys autozone and advance can't seem to understand the joint is not the same on both sides.Mabey thiat is where mickey dees employies go when they burn one too many baskets of fries.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
