Forums
Forum Tools
|
 |
00:22:22 - 12/20/2024
V8 Dakotas
| From | Message |
DakotaFlames
Dodge Dakota
JOIN HERE
4/09/2005
16:01:54
|
 Subject: Trans Help
IP: Logged
Message:
I just bought a new trans from APS Precision, has anyone used them before here? If so I would like to install myself, can anyone give me some tips on what to do. Its 46RE I think. 99 4x4 5.2
|
Kaderdak
GenIII
4/11/2005
01:24:00
| RE: Trans Help
IP: Logged
Message:
I haven't installed such a transmission, but I have removed and reinstalled the original tranny on a '97 5.2 4x4.
Tips huh? I did the whole thing just a few months ago, was really the first time I'd ever done tranny work before. I basically just walked myself through it and learned a TON in the process. If I could offer a few tips it would be these.
1.) Get at least one friend to help
2.) Be 110% sure you get the torque converter completely seated into the new transmission. There should be approx. 1/8" gap between the bolt holes in the torque converter and the flexplate. Be sure you get the bolts torque correctly (very difficult in a tight area.)
3.) If you've never done anything like this before, don't even think about starting without some kind of manual.
4.) Be ready to have a lot of scraped up knuckles when you get done :)
** '97 Dakota 5.2L 4x4 w/3.55(my best ebay purchase yet) **
** Homebrew CIA, Dynomax Catback, March Underdrive Pulleys, Transgo Kit **
** Borg Warner Brass Cap/Rotor to Taylor 8mm wires to NGK plugs **
** Homebrew dual electric fan setup with 180* thermostat **
** Sitting on BFG 31 x 10.50's **
** Tons more once I'm not a poor college student :) **
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
