| From | Message |
robert badia
Dodge Dakota
JOIN HERE
3/23/2005
19:04:34
|
 Subject: roller to flat tappet
IP: Logged
Message:
can i convert roller to flat tappet on a 97 318 magnum motor
thank you
|
Mike S.
Dodge Dakota
JOIN HERE
3/23/2005
19:40:18
|  RE: roller to flat tappet
IP: Logged
Message:
Yes, it can be done but you'll need some custom length pushrods too take the place of the stock ones. You will also need a new cam bolt with fuel pump eccentric eliminator. This may or may not cause a fitment problem with your timing cover. The snout on the front of a flat tappet cam is longer (to make room for the fuel pump eccentric). On my 91 I had too modify the stock timing cover so it would fit. Even though my 91 was a pre-mag motor it still had the roller cam. Hope this helps.
Mike S.
91cc Carbed 390 w/nitrous
7.47 @ 94.23 (1/8th mile)
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
