| From | Message |
trpdakota
Dodge Dakota
JOIN HERE
11/14/2003
12:01:54
|
 Subject: headers
IP: Logged
Message:
Does anyone know if there is a difference between the 4.7 in 2000 and 2001? I found a set of headers that i would like to buy off a wrecked 2000, but am unsure if there were any changes in 2001. Also, after removing the stock headers will the aftermarket (borla) bolt right on? I'm not much of a gearhead so any help would be appretiated.
|
steve sharp
Dodge Dakota
JOIN HERE
11/14/2003
13:24:45
| RE: headers
IP: Logged
Message:
I know that the headers will work, but call borla about the exaust set up. their exausts are usually a cat back system so it shouldnt be a problem, but get the info first.
|
correct ans
Dodge Dakota
JOIN HERE
11/15/2003
06:50:41
|  RE: headers
IP: Logged
Message:
it will fit!
|
skitter
Dodge Dakota
JOIN HERE
11/15/2003
19:44:14
| RE: headers
IP: Logged
Message:
hey if you don't put them on sell them to me!!!!!!!!!!!!!!!!
|
01Motorsport
Dodge Dakota
JOIN HERE
11/15/2003
21:17:39
| RE: headers
IP: Logged
Message:
The factory 4.7 exhaust manifolds flow to within 2% of headers. 2000 had 65mm throttle body, 2001 had 68mm.
|
Mahler
Dodge Dakota
JOIN HERE
11/15/2003
21:33:10
| RE: headers
IP: Logged
Message:
01Motorsport:
That is an interesting stat. Headers, esp. Borlas, are too expensive for the gains received. And they are noisy! And Borla is entirely too proud of their stuff, pricewise.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
