| From | Message |
McGuire
Dodge Dakota
JOIN HERE
11/11/2003
07:37:30
|
 Subject: HELP!!!!!
IP: Logged
Message:
i have a 4.7L that is running like sh#t right now. its hard starting...and at 2500 r.p.m. it will cut power (like a rev. limiter). i checked the fault code and said P0320. i replaced it with a new one. still hasn't fixed the problem. what should i do next?
|
b
Dodge Dakota
JOIN HERE
11/11/2003
07:59:53
|  RE: HELP!!!!!
IP: Logged
Message:
fuel pump or cat one of the two
|
McGuire
Dodge Dakota
JOIN HERE
11/11/2003
09:15:34
| RE: HELP!!!!!
IP: Logged
Message:
i'll try that but i don't understand why the fault code P0320 still shows up even after its been replaced? or why it even showed the fault in the first place if it was the cat. or fuel pump. know what i'm saying! ?????
|
KS_DAK47
Dodge Dakota
JOIN HERE
11/11/2003
09:51:50
| RE: HELP!!!!!
IP: Logged
Message:
you may have to reset your computer to get rid of the fault code. When i had a 3.9 V6 i had to do the same to clear the fault code and check engine light. Hope this helps.
|
mcguire
Dodge Dakota
JOIN HERE
11/11/2003
10:21:50
| RE: HELP!!!!!
IP: Logged
Message:
Thanks but i already reset the computer by unpluging the battery. no luck
|
Dude
Dodge Dakota
JOIN HERE
11/11/2003
11:27:54
| RE: HELP!!!!!
IP: Logged
Message:
Unplug the battery, then turn the ign. key to start for 15-30 seconds. That clears out the entire computer fault code bank.
|
Yogi
Dodge Dakota
JOIN HERE
11/11/2003
15:46:39
|  RE: HELP!!!!!
IP: Logged
Message:
Take it to the dealer. It sounds like your cat is bad. Fed law requires the dealer to warranty the cat for 8yrs/80K mi. I just had mine replaced at 54K.
|
Confused
Dodge Dakota
JOIN HERE
11/11/2003
16:40:43
| RE: HELP!!!!!
IP: Logged
Message:
You replaced "it" with a new one ? What did you replace ?
|
McGuire
Dodge Dakota
JOIN HERE
11/14/2003
06:49:04
| RE: HELP!!!!!
IP: Logged
Message:
i replaced "it" being the sensor.
|
HUH
Dodge Dakota
JOIN HERE
11/14/2003
16:03:56
| RE: HELP!!!!!
IP: Logged
Message:
Which sensor ?
|
McGuire
Dodge Dakota
JOIN HERE
11/14/2003
23:45:09
| RE: HELP!!!!!
IP: Logged
Message:
Fault code P0320 is the Crankshaft position sensor reference signal cannot be found while the engine is cranking. this is the fault code on my computer right now. and even after it has been replaced my truck now runs worse! and the fault code hasn't went away! by worse i mean that it has become very hard starting sence i replaced that sensor pluse it still has that old problems of which i alread talked about.
|
Kowlski
Dodge Dakota
JOIN HERE
11/15/2003
07:46:45
| RE: HELP!!!!!
IP: Logged
Message:
How many miles on your truck ?
|
McGuire
Dodge Dakota
JOIN HERE
11/15/2003
10:54:44
| RE: HELP!!!!!
IP: Logged
Message:
only 22,000 miles. i'm in the army so when go do ....Army stuff..lol it sits for a few months at a time untill i get back
|
Kowalski
Dodge Dakota
JOIN HERE
11/15/2003
11:48:43
|  RE: HELP!!!!!
IP: Logged
Message:
Then just go with Yogi's suggestion - you're covered. Please let us know what it is once you get it fixed. I doubt its the cat but almost everything that would set the MIL light except for plugs and filters should be covered by that federal emissions warranty.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
