| From | Message |
P
Dodge Dakota
JOIN HERE
9/01/2003
13:17:41
|
 Subject: Will not idle...
IP: Logged
Message:
Hello,
I was wondering if you all can give me some pointers on why my truck will not idle after the battery went dead. I can jump the truck and it will start but will not idle/run on its own.
Thanks, P
|
TheDonNonn
Dodge Dakota
JOIN HERE
9/01/2003
13:31:32
|  RE: Will not idle...
IP: Logged
Message:
what engine?
|
P
Dodge Dakota
JOIN HERE
9/01/2003
14:17:31
| RE: Will not idle...
IP: Logged
Message:
4.7L
|
rtdkota
R/T
9/01/2003
14:42:05
| RE: Will not idle...
IP: Logged
Message:
You have retrain the idle on the 4.7s...
Start it-- help it idle with the pedal-- get it to about 1000 rpm-- once that settles, or shortly thereafter-- put it into drive if it's an automatic (with foot on the brake) and hold the idle around 1000-1100 rpm, in gear, brake on for about 60-90 seconds.
This will allow the IAC to sync the idle.
If you have problems/questions. Call me.
Sam
619-274-1292
www.socaldakota.com
|
P
Dodge Dakota
JOIN HERE
9/01/2003
15:13:34
| RE: Will not idle...
IP: Logged
Message:
Sam,
I thank you very much for your input!!! It worked, but you knew that it would. Thanks again! P
|
Tom J.
Dodge Dakota
JOIN HERE
9/01/2003
15:26:21
| RE: Will not idle...
IP: Logged
Message:
Hey Sam... I just installed a KRC206 cam in my 2002 Ram with 4.7l engine. My idle is all screwed up now and I can't seem to fix it. I have a F&B 70mm TB and I have tried to adjust it according to KRC instructions. It says to plug the hole for the IAC and adjust to 700-900rpm(your preference) and then unplug hole and engine rpm will surge but then will drop to 700-900rpm and stay there steady. My problem is that since I installed this cam my idle droped to 550-600. I am used to the normal idle I had of about 750 before the cam and I also have an underdrive pulley installed and need to be closer to 800rpm to satisfy the charging system. After I adjusted the TB the way KRC suggests my idle won't drop below 1300rpm. I am hoping that you might have some suggestions or different adjustment procedure to get back a normal idle rpm. Thanks TJ
|
reece
Dodge Dakota
JOIN HERE
9/17/2013
08:57:48
| RE: Will not idle...
IP: Logged
Message:
Same problem with a friend's truck Tried the remedy listed by applying the break and holding rpms. Did not work in this case. Did we miss something?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
