| From | Message |
88 Dakota
Dodge Dakota
JOIN HERE
8/05/2003
05:34:45
|
 Subject: Engine Swap
IP: Logged
Message:
I know a 318 will, but does anybody know if a 360 will bolt to my V-6 tranny. I know the blocks are similar but is the bell housing pattern different. Has anybody done this swap yet? '88 Dakota V-6 (swap to smallblock) I have a '68 340 intake that will fit 318 through 360.
|
kowalski
Dodge Dakota
JOIN HERE
8/05/2003
15:07:37
| RE: Engine Swap
IP: Logged
Message:
should be same bellhousing.
|
88 Dakota
Dodge Dakota
JOIN HERE
8/08/2003
02:37:18
| RE: Engine Swap
IP: Logged
Message:
Have you seen anybody do a 360 w/ V6 5spd. I hope you are right, would like to keep the same tranny, right where it is!
|
rogerv1
Dodge Dakota
JOIN HERE
10/16/2007
00:22:40
|  RE: Engine Swap
IP: Logged
Message:
I am also wanting to do a 93 4x4 v6 to 5.2 v8 am wondering if the auto trans will match and if I am going to have computer or sensor issues. how about the mounts.
|
gen1dak
Dodge Dakota
JOIN HERE
10/16/2007
02:50:02
| RE: Engine Swap
IP: Logged
Message:
Same bolt pattern on the tranny and mounts. You will need a torque converter for the '92-'95 318 so the fuel injection will work properly. The converter on the V6 unit has 6 "windows" for six cylinders. The 318 has 8 for obvious reasons. These "windows" are vital to the proper timing of the entire MPI fuel and ignition timing. You will also need the V8 computer, engine harness, and distributor.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
