| From | Message |
wesleymd
Dodge Dakota
JOIN HERE
7/25/2003
09:44:19
|
 Subject: dodge coumputer
IP: Logged
Message:
I was thinking of puting a modern 360 in a old car,with big indy heads. is there any way to make the computer flow enough fuel on the original pcm or do you have to buy a high priced aftermarket computer and if so how much? thanks.
|
dcxer
Dodge Dakota
JOIN HERE
7/27/2003
13:22:04
|  RE: dodge coumputer
IP: Logged
Message:
First if you have enough money and time you can get almost any combo to work.As I recall the Indy heads are for pre-Magnum engines only.Magnum intakes will not fit pre-Magnum engines.A custom intake would be very expensive.(+1000.00)You would make it much easier with the MP heads for a Magnum and the matching MP computer.Cheaper too.You could even run the Magnum engine with a carb and do away with the computer and fuel injection.MP also makes an intake for that.A professionally modified set of the MP heads will put out air flow very close to the Indy heads.If you had access to the right equipment you could flash any cal into the stock computer.Its just a lot easier to use the MP stuff out there.
|
mohamed
Dodge Dakota
JOIN HERE
8/31/2003
23:00:11
| RE: dodge coumputer
IP: Logged
Message:
i wanan that refile if you could send me any information about it i will be so glad
his-amd
2m(2k000628)
v 4.51 pg
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
