| From | Message |
gps_jetskier
Dodge Dakota
JOIN HERE
6/30/2003
07:58:45
|
 Subject: HO Cam club - new member
IP: Logged
Message:
I got the HO cams installed this week. I was hoping it would give me tire shredding power, but alas...it only spins & barks the 33's. It's made up for the power I lost when lifting and going to bigger tires. I was nervous doing it, but it's not that bad if you go slow. I ran into some problems with the pdf instructions floating around here. It says to remove both cam senders. I could only find one. The other thing is I could not properly torque the drivers side cam sproket because the steering pump res is in the way to get a wrench in there. You have to remove all the power steering stuff. I didn't want to do that so I just gave it a REALLY good umph. HINTS: go get a torque wrench that reads inch punds. I converted the number to ft pounds (8ft/lbs) and it made my wrench seem inacurate.
JOIN THE CLUB...it was worth the 5 hours.
GPS_JETSKIER
01QC, 3"Body Lift, 285 BFG AT's
IAT adjuster, Powerslots/Hawk Pads, No 3rd Cat
Bored 68mm TB, SS Nerfs, Line-X
Custom Safari Rack & light Bar
now HO CAMS
|
TheDonNonn
Dodge Dakota
JOIN HERE
6/30/2003
09:43:04
| RE: HO Cam club - new member
IP: Logged
Message:
Why am I the only one who's had trouble with the cams??!?!
One good thing about it...they've been in and out three or four times now..I'm a pro at wiggling those covers out.
|
gps_jetskier
Dodge Dakota
JOIN HERE
6/30/2003
10:22:45
| RE: HO Cam club - new member
IP: Logged
Message:
What problems did you have? Mine stubbled when I first fired it up and even after running a bit. Then I undid the battery for a bit and fired it up again. Seems to be ok now.
|
TheDonNonn
Dodge Dakota
JOIN HERE
6/30/2003
12:37:49
| RE: HO Cam club - new member
IP: Logged
Message:
gps...if you read the post "just my luck" it says it all there.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
