| From | Message |
Waltherone
Dodge Dakota
JOIN HERE
1/30/2003
20:40:06
|
 Subject: Installing B&M cooler
IP: Logged
Message:
Hey all, I've got a 4.7 w/ the 45RFE tranny, I got my B&M today, I wasn't sure which line coming out of the tranny to the stock cooler was the return and which was the sending line, and the installation sheet said on all chrysler RWD trannies the REAR line is the return, except on mine, the two lines are right above each other. The bottom one is about a half inch closer to the rear than the top, but I want to make sure that that one (the bottom one) is in fact the cooler return?
|
Waltherone
Dodge Dakota
JOIN HERE
1/31/2003
21:49:05
| RE: Installing B&M cooler
IP: Logged
Message:
^
|
dickc
Dodge Dakota
JOIN HERE
1/31/2003
23:24:55
| RE: Installing B&M cooler
IP: Logged
Message:
According to the '01 Service Manual the lower aft fitting is "from cooler" for the 45RFE transmission.
Dick
|
Waltherone
Dodge Dakota
JOIN HERE
1/31/2003
23:34:57
| RE: Installing B&M cooler
IP: Logged
Message:
Alright, thanks :)
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
