| From | Message |
slider_buck
Dodge Dakota
JOIN HERE
1/10/2002
18:23:36
|
 Subject: headers cracking
IP: Logged
Message:
i have a set of flowtech headers on my truck that have gotten cracked. the piece that curves up by the brake booster evidently has been rubbing when the motor twists and it has put a big crack around it. has anyone else had this problem? how close is your guys header to touching the brake booster?
|
andrew
Dodge Dakota
JOIN HERE
2/23/2002
23:19:37
|  RE: headers cracking
IP: Logged
Message:
so what ended up happening?
|
slider_buck
Dodge Dakota
JOIN HERE
2/26/2002
05:52:57
| RE: headers cracking
IP: Logged
Message:
i had to put on a different set of headers. i went with the gibson headers. instead of curving up by the booster they curve beside each other, no clearance problems with these.
|
andrew
Dodge Dakota
JOIN HERE
2/26/2002
11:38:28
| RE: headers cracking
IP: Logged
Message:
How much did you pay for the gibsons? I am thinking about getting a set of those flowtech smog legal headers for under $200. Were they any good at all?
|
gixsaar
DakotaEnthusiast
3/05/2002
12:23:58
| RE: headers cracking
IP: Logged
Message:
I was thinking about going with the JBA stainless headders and then having them Jet Hot coated.
Good set-up...of would there be a better way?
I'm interested in getting the highest flow exhaust possible, and am willing to wait/pay for whatever it takes.
Thanks guys, this board rocks!
|
gixsaar
DakotaEnthusiast
3/05/2002
12:26:56
| RE: headers cracking
IP: Logged
Message:
After the headders I'm planning on using Car Sound cats, and Spin Tech mufflers.
|
drtswinger
Dodge Dakota
JOIN HERE
3/06/2002
09:39:25
| RE: headers cracking
IP: Logged
Message:
Flowtech- Junk.... I know this from experience. both on my previous Dart, and some of my friends cars.
|
Raymond
Dodge Dakota
JOIN HERE
11/06/2003
15:14:11
|  RE: headers cracking
IP: Logged
Message:
I have a 98 dakota with flowtech headers. I also have the 3" fabtech lift. my problem is the passenger header is extremly close th the upper a arm bushing and it melted the bushing out. does anyone else have this problem and is there a fix. Help!!
|
Woodrow
Dodge Dakota
JOIN HERE
11/16/2003
21:45:56
| RE: headers cracking
IP: Logged
Message:
Hey, Raymond
I have a 93 5.2 2 wheel drive and that happened to me also I have Headmans on mine,I just replaced the bushings and it raised it about an inch.I think that it might need some kind of a heat shield put on it.I haven't really looked at it anymore.
|
Raymond
Dodge Dakota
JOIN HERE
11/17/2003
12:43:36
| RE: headers cracking
IP: Logged
Message:
Thanks for the reply woodrow I replaced the bushing and while i was at it I removed the header and wrapped in, I just got back froma trip and the bushing melted again. I gues i just have to remove the headers.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
