Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
01:14:31 - 12/20/2024

V8 Dakotas
FromMessage
gotanRT
Dodge Dakota
JOIN HERE
 Email

7/02/2003
00:23:34

Subject: RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
it should be under warranty, i asked my friend about it he said its a common sensor to fail with a dodge transmission...but it might not be the problem, if it's free than its worth a shot...



2002DakotaRT
Dodge Dakota
JOIN HERE
 Email

7/09/2003
16:57:24

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
TTT



?
Dodge Dakota
JOIN HERE


7/10/2003
01:54:48

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
what? what? what?



96hokie
Dodge Dakota
JOIN HERE
 Email

7/12/2003
14:58:12

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
I had this problem. I thought the transmission was fried and my truck (2000 Quad Cab 360) was 4000 miles out of warranty. I took it to a Dodge dealership and they told me I needed a $4500 transmission. I told them to !@#$ themselves. I then took it to a shop in town and they replaced some sensor. Cost about 100 bucks. My Dad's Durango had the same problem. I'll bet that's it that sensor thing that has gone bad and your tranny is in "fail safe" where it is stuck in 1st gear.



WELKON
Dodge Dakota
JOIN HERE
 Email

10/12/2003
18:23:38

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
sAME THING STARTED ON MY 02' DAKOTA 5.9 AND AFTER HAVING DIAGNOSTICS RUN AT LOCAL SHOP, THEY THINK IT IS THE GOVERNOR PRESSURE SENSOR ALSO. THEY HAVE TO TALK TO DEALER TO GET PART TOMORROW SO I SHOULD KNOW FOR SURE. DIAGNOSTIC CODES WERE:

P1762 (M) Governor Pressure Sen Offset Volts Too Low Or High Sensor input greater or less than calibration for 3 consecutive Neutral/Park occurances. (4-speed auto. Trans. Only)

AND

P1757 GOV Pressure Not Equal To Target @ 15-20 PSI The requested pressure and the actual pressure are not within a tolerance band for the Governor Control System which is used to regulate governor pressure to control shifts for 1st, 2nd, and 3rd gear. (Zero Pressure Malfunction)



Eli82
Dodge Dakota
JOIN HERE


4/07/2004
21:38:28

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
I have a 2002 5.9 R/T with 31,900 miles and when floored it will not shift out of first gear. It's as if it hits a rev limiter and will not shift. I have to back off and eventually it will shift into the next gear. I have no engine codes at this time either.

My problem sounds JUST like a lot of other threads I've read. My Dodge dealership here is really terrible, so I will have to print this thread so they will at least see I'm not the only one with the problem. It's April 2004, anyone with updated info please post. Thank you!



Ted 00 R/T
Dodge Dakota
JOIN HERE


4/12/2004
11:18:23

RE: 5.9 Durango R/T won't shift when f
IP: Logged

Message:
I too am still looking for some more up todate soultions to this problem. Does anyone have an for sure ideas theat have wroked on the 5.9 Durago R/T



welkon
Dodge Dakota
JOIN HERE
 Email

4/12/2004
12:03:00

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
Replacing the GPS - governor pressure solenoid fixed the problem for me. Dodge dealer did it and didn't seem at all surprised about it. Seems to be a pretty common occurence with this transmission.



jasonclutte
Dodge Dakota
JOIN HERE
 Email

4/12/2004
19:11:38

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
The problem with it not shifting out of first is because the rev limiter of the truck is to close to the shift point out of first and wide open throttle. My truck has the same problem. With the other problem their is a cheap sensor that has gone bad.



aracn8ped
Dodge Dakota
JOIN HERE


6/30/2004
13:34:05

RE: 5.9 R/T won't shift from 1st @ 5500 RPMs
IP: Logged

Message:
Had the same problem on my sons 2000 5.9 r/t. It would not shift out of 1st but hit the revlimiter when the pedal was to the floor. Took it to my local transmission shop. They diagnosed and adjusted the TV cable for $25. It fixed the problem and it shifts fine now.



  <<Previous Page P 2 Next Page>>


 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.