darcy
Dodge Dakota
JOIN HERE
8/20/2002
02:55:44
|
 Subject: 4.7 Intake question...
IP: Logged
Message:
With this HO manifold and cams, I'm just wondering, is the cams the same as the ones on this page? http://www.krcperformance.com/krc_performance_47.htm
If not, would it be better to get the HO manifold and theses cams or the HO manifold and the HO cams (if their different) Hope that made some sense...
Also...I just built a home-brew ABS intake with a K&N filter and I have a few concerns. I used a 3" Fernco rubber coupler to join the intake to the TB, now I just tightened the hose clamps as tight as I could, so much that it is noticably squeezing the rubber...should I back them off a bit or keep it this way to ensure a good seal. Secondly, I used piping with a 3" inner diameter and a K&N filter which had a 3 inch inner diameter so, obviously, the inside of the rubber on the filter had to fit over the outside of the ABS piping which, of course, is not 3" so I had to stretch the hell out of it to make it fit. Is it possible that this could damage it, it seems to be fine, I sanded the pipe down and smoothed out the edges so it would go over easier but it is still a 3" inner diameter that has been stretched out to about 3 1/2". Sorry for the rediculously long post, I'm just paranoid about this stuff!
|
