Beer Kegger - Dodge Dakota Forum

Subject: Beer Kegger
IP: Logged

Message:
Anyone done any major modifications on those magnum beer
kegs? Welding, machining, boring...etc???

I have 3 kegs laying around and nothing to do this weekend.....

dakownr
Dodge Dakota
JOIN HERE

2/03/2010
10:56:58

RE: Beer Kegger
IP: Logged

Message:
Some folks on here have cut out a large portion of the center divider inside the intake. They have also cut the runners down a bit. I think that there is a thread on this site somewhere that describes what I'm speaking of. If I remember correctly, the person (or people) that have done this say that they were pleased with the results.

If you have or could get a set of intake manifold gaskets, you could grind the ports to match the gaskets. Of course, this would do you more good if you also port-matched the intake ports on the head, as well.

dakownr
Dodge Dakota
JOIN HERE

2/03/2010
11:22:30

RE: Beer Kegger
IP: Logged

Message:
Try this link:

http://dodgeforum.com/forum/2nd-gen-ram/145873-kegger-intake-mod-diy.html

This guy cut the runners on a goofy-looking angle, and one of the other posters commented on it. I am not sure if cutting the runners like that are better or worse than cutting straight. Perhaps someone with better knowledge of airflow can comment on this...

daddio
Dodge Dakota
JOIN HERE