| From | Message |
Jun
Dodge Dakota
JOIN HERE
11/21/2009
23:00:13
|
 Subject: `03 CC RT engine light/ pressure governo
IP: Logged
Message:
Hi everyone. I was wondering if there's someone in OC that does tranny work. I went to get my truck smogged and they failed me because my check engine light was on. After visiting a couple shops, they pointed to the pressure governor. Is there someone on here in SoCal/OC area with an OBDII and the capability of solving my probs?
Thanks in advance!
Jun
|
Jun
Dodge Dakota
JOIN HERE
11/21/2009
23:02:21
|  RE: `03 CC RT engine light/ pressure governo
IP: Logged
Message:
Ooops.... forgot to post the codes.
P1762 (M) GOV Pressure Sen Offset Volts Too Low Or High The Governor Pressure Sensor input greater or less than calibration for 3 consecutive Neutral/Park calibrations.
P1762 (M) Governor Pressure Sen Offset Volts Too Low Or High Sensor input greater or less than calibration for 3 consecutive Neutral/Park occurances. (4-speed auto. Trans. Only)
P1899 (M) P/N Switch Stuck In Park Or In Gear Incorrect input state detected for the Park/Neutral switch.
P1899 (M) P/N Switch Stuck In Park Or In Gear Incorrect input state detected for the Park/Neutral switch (3 or 4-speed auto. Trans. Only).
|
Chief
Dodge Dakota
JOIN HERE
11/26/2009
13:11:33
| RE: `03 CC RT engine light/ pressure governo
IP: Logged
Message:
sounds like you need a governer presure switch in the tranny, i was getting similar codes right b4 the tranny went out of mine. Mine is an 02 RC R/T
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
