Adam H
Dodge Dakota
JOIN HERE
2/03/2009
14:08:00
|
 Subject: 5.2 performance mods
IP: Logged
Message:
Hi I just picked up a 94 5.2 out of a Jeep Grand Cherokee. I don't believe I am going to rebuild the motor completley as it has good compression. 1~180,2~165,3~170,4~160,5~160,6~170,7~160,8~170 The intake gaskets are leaking and the intake manifold gasket is blown (to be expected). I plan on putting the Mopar M1 intake P5007398AB and install kit P5007638. I am undecided if I am going to put the a cam from Krc in KRC 206 206/210-480/512 112 or if I am just going to put in 1.7:1 Harland sharp RR. I eventually plan on putting in a 50mm throttle body and the Mopar Performance PCM P5249545.... If any one has any advice on witch way I should go, or if you have a set up you like and would recommend any advice would be appreciated. The engine is going to replace my 3.9 eventually, so it is going to be a slow build I am in nothing of a hurry and would rather do it right when it is out than do it again when it is in. I use the truck for towing but it also can’t be afraid of the high rpm.
Thanks for all the help
Adam H
|
