Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
01:18:11 - 12/20/2024

V8 Dakotas
FromMessage
socalrws
Dodge Dakota
JOIN HERE
 Email

8/16/2007
19:38:25

Subject: '94 4x4 Dakota 5.2L
IP: Logged

Message:
Getting Code 12 and 27 on fault codes.
12=memory standby power lost
27=Injector output circuit not responding

How do I fix above codes?

Other symptoms on cold start it goes into a LIMP mode and check Eng lite goes on. One or two cylinders not firing. When engine heats up and I restart the problem goes away. It has SBEC II computer. Can this be the O2 sensor? I't has 4-wires with heater. I'm thinking heater on O2 is defective. But after 1st warm up the problem goes away and won't come back till sitting overnight.

160K miles now. Last Smog Test was 11K ago and all levels of CO, NOx, HC was extra low. I had just put in a new CAT, O2 sensor, EGR valve & TPS.

I also noticed a loss of coolant in the reservoir. Nothing in oil or ground, can't figure out where its going.

I need to pass SMOG TEST next month.

:o)



PB
Dodge Dakota
JOIN HERE
 Email

8/17/2007
01:17:07

RE: '94 4x4 Dakota 5.2L
IP: Logged

Message:
i got the same same set of codes but that means the injector isn't firing. 12 really doesn't mean much other than the battery was disconncted. 27 on the other hand is bad check the injector wiring and all engine grounds. if those are still good, i think its a new pcm. Mine would die and #7 injector wasn't firing. I had to replace my pcm. $248 from mopar

sorry about that emissions test, that sucks




socalrws
Dodge Dakota
JOIN HERE
 Email

8/20/2007
03:27:40

RE: '94 4x4 Dakota 5.2L
IP: Logged

Message:
Don't fault codes come from ecm?
so if it's a bad ecm how do you verify?
thx



PB
Dodge Dakota
JOIN HERE
 Email

8/20/2007
12:03:22

RE: '94 4x4 Dakota 5.2L
IP: Logged

Message:
When my pcm went i could still pull codes, but it couldn't run the truck hardley, for a long time before that it would have an injector not firing. Then it started dieing on me and i finally figured a bad pcm. it wouldn't run the truck but i could still pull codes.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.