| From | Message |
truck guy
Dodge Dakota
JOIN HERE
3/04/2007
14:59:15
|
 Subject: oil pressure sender unit
IP: Logged
Message:
Hey guys, I just spent the last hour tring to remove the wire harness clip off of the oil pressure sending unit. I couldn't remove it. It looks like there's a red colored slid lock across the side of the harness, but because of it's location I can't see how to remove it from the sending unit--- I don't want to break anything. Has anybody removed one of these before and how did you do it?
|
partsmanager
Dodge Dakota
JOIN HERE
3/04/2007
15:28:50
| RE: oil pressure sender unit
IP: Logged
Message:
slide it over till it clicks. It stays on the clip you dont have to remove it to disconnect the connector then squeeze the tab and pull back once you see how it works you'll be doing them by feel. the slide lock is a good idea but it was made for people with small fingers/hands like most things
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
