| From | Message |
DEREK J.
Dodge Dakota
JOIN HERE
5/14/2002
20:46:55
|
 Subject: t-stat install ?
IP: Logged
Message:
after i install my 180 t-stat on my 2002 4.7 how do i bleed the cooling system. thanks for all your guy's and girl's help.
|
kevster
Dodge Dakota
JOIN HERE
5/14/2002
22:06:08
|  RE: t-stat install ?
IP: Logged
Message:
I just remove cap and fill slowly, start truck let run and fill again, till it is full, install cap, make sure resevoir is at full line on stick also. drive for a while, let cool and remove cap check again. top off if needed, check resevoir also. Good luck.
|
handi2
GenIII
5/14/2002
22:11:46
| RE: t-stat install ?
IP: Logged
Message:
I did the same thing. Just as Kevster with no problems. Just let the engine idle after filling as much as you can thru the cap. The air will bleed out thru the open cap. Take plenty of time and check everything after a drive when everything cools down.
http://photos.yahoo.com/handi254310
2002 Quad Cab SLT Plus 4.7 Every Available Option
Access Tonnoue Cover/Bedrug/360 Air Intakez/Jet Stage 2
180 Robertshaw/Roadmaster Active Suspension
Street Scene Grill Inserts
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
