Forums
Forum Tools
|
 |
23:29:44 - 12/19/2024
V6 Dakotas
| From | Message |
David
Dodge Dakota
JOIN HERE
8/18/2004
10:05:35
|
 Subject: Air Intake Position
IP: Logged
Message:
Hello, was wondering what is the correct position to put the air intake? Should it be up high, say near the fender, or down low near the opening where we removed the 4" air flap? What would give you better results? I can position mine in either position, so was just wondering. By the way i have the 360 in mine. thanks...
|
xmr
GenIII
8/18/2004
11:06:02
|  RE: Air Intake Position
IP: Logged
Message:
Down low as close to the cold air as possible. The more cold air the better.
'98 cc auto /Home brew cold air with K&N,Dynomax, Superchip Tuner, 1.7 RR,, F&B tb. NAPA cap and rotor, 3923 plugs,tps mod,relocated & switchable iat, 180 t'stat, Crankshaft sensor mod.,PVI,Ported and Polished manifold, bosch injectors,Black Magic Elec Fan, msd wiires
|
2shay
Dodge Dakota
JOIN HERE
8/18/2004
17:18:23
| RE: Idle Too High
IP: Logged
Message:
Hello! Just looking for some advice. I have a 95' Dakota 3.9 auto. Yesterday I took a can of intake/TB cleaner and did the cleaning procedure(manually revved engine to make butterflys open and then sprayed into for 10 seconds then waited 10 seconds until bottle was gone. After this I installed my new K&N Air Filter. I then went across street to get gas started it and then after I got gas noticed it had 1500 rpm idling speed. Before all of this I had 500 rpm idle speed. I am not a mechanic but I noticed that when you are in front of the bumper looking at engine and you look at cables that connect to throttle the cable nearest the TBI is slack I have read about resetting the PCM? What is PCM? Any advice would be appreciated.
|
David
Dodge Dakota
JOIN HERE
8/19/2004
17:32:07
| RE: Air Intake Position
IP: Logged
Message:
Reset your PCM by disconnecting your neg battery cable, then put key in and turn to start position for about 30 secs. turn back to off. reconnect your neg battery cable, and start truck. Do not hit the accelerator. let run for about 30 secs, turn off, and then turn back on. This allows for Computer to reset itself to the new air intake. any other questions feel free to ask.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
