Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
23:29:51 - 12/19/2024

V6 Dakotas
FromMessage
Wadak
GenIII
 User Profile


8/12/2004
12:38:34

Subject: Check Engine Light
IP: Logged

Message:
Recently, I completed most of the mod's I had planned for this 97 v6 Dakota. I then realized I needed to readjust the fuel sync according to Larry's instructions(from appr. -6 to appr. +3). I not ge a check engine light after doing this, I have scanned the OBD 2 port and the trouble shows up as Ignition Coil Malfunction, primary or secondary. I had temporarily replaced the coil, replaced the spark plug wires with a backup set I keep, distributor cap and rotor, I even added an additional ground to coil and cleaned all the grounds between engine block and ground. None of the things I have tried will clear the check engine light. I can clear the trouble light with my Autoxray scanner, it will come back on. Does anyone have any thoughts or suggestions.



Bob Lincoln
Dodge Dakota
JOIN HERE


8/12/2004
12:43:23

RE: Check Engine Light
IP: Logged

Message:
"I have scanned the OBD 2 port and the trouble shows up as Ignition Coil Malfunction"

"I even added an additional ground to coil"

I think there's your answer. Diagnostics probably found out-of-range resistance or voltage in coil circuit due to this 'additional ground'. remove it, clear codes and check again.



GB2000
GenIII
 User Profile


8/12/2004
13:13:05

RE: Check Engine Light
IP: Logged

Message:
Bob,
I think he's saying he added it to try and clear the light...I don't think it was there when the light first came on.

Josh

http://www.cardomain.com/id/sentenced

Wadak
GenIII
 User Profile


8/12/2004
13:56:24

RE: Check Engine Light
IP: Logged

Message:
Bob, I have the check engine light with or without the ground. I added the ground after getting the check engine light.



Wadak
GenIII
 User Profile


8/13/2004
18:40:31

RE: Check Engine Light
IP: Logged

Message:
I backed off the fuel sync adjustment, a small amount and resolved the check engine light, I must have had it advanced too much. The truck ran very well at this setting. I was baffled to see a check engine light that indicated ignition coil malfunction.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.