| From | Message |
Nirr
Dodge Dakota
JOIN HERE
7/03/2004
18:38:06
|
 Subject: Edelbrock Pro-Flo 1000 Air Filter
IP: Logged
Message:
On the Edelbrock Pro-Flo 1000 Air Filter, do I need to modify the bolt on my carb, or do I need to make an S-bolt to fit it?
Thank you in advance
|
GB2000
GenIII
7/03/2004
19:16:40
| RE: Edelbrock Pro-Flo 1000 Air Filter
IP: Logged
Message:
If it's like the gen 3's bolt...you'll need to make an s-bolt. The stock bolts are too short. S-bolts are cheap and easy to make anyway... I think the total cost of mine was like $2 and I still have about 3/4 of that rod left. Just remember not to trace that picture exactly if you use the one from Speedtweaks...it's not drawn to scale and more than likely won't fit. Use the description and design your own pattern then just bend the rod to the pattern.
Josh
|
Nirr
Dodge Dakota
JOIN HERE
7/03/2004
20:51:57
| RE: Edelbrock Pro-Flo 1000 Air Filter
IP: Logged
Message:
Thanks, but actually the rod that was already on my carb was too long for the application. So I just hacked some of it off.
Looks nice too, but I will have to wait till tomorrow to open her up and see if there is any real differance with it on there.
Thanks anyway
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
