| From | Message |
Just Looking
Dodge Dakota
JOIN HERE
6/20/2004
03:35:46
|
 Subject: Intake manifold torque specs
IP: Logged
Message:
Heh since i got my vehicle down for a week its
time for some modding >:)
power pulley on :)
Now im grinding on the intake manifold but im not sure of some things...
Can i reuse the bolts off the intake manifold, what do i torque the bolt down to, and in what pattern?
Any tips would be greatly appreciated and thanks in advance.
|
Just Looking
Dodge Dakota
JOIN HERE
6/20/2004
12:39:48
|  RE: Intake manifold torque specs
IP: Logged
Message:
Forgot to mention its a 2002 with the 3.9
i ordered the seals in and im assuming that the seals for a 97 will work if not let me know.
Thanks
|
J and J Auto
GenII
6/20/2004
14:49:17
| RE: Intake manifold torque specs
IP: Logged
Message:
Just wire wheel the threads and reuse the bolts
Intake 12 to 14 foot pounds
pletium cover 14 to 16 foot pounds and blue locktight
silicon all 4 corners where the rubber seal meats
the gaskits lay a bead there and all will be fine
Larry
J&J Auto
|
Just Looking
Dodge Dakota
JOIN HERE
6/23/2004
02:58:39
| RE: Intake manifold torque specs
IP: Logged
Message:
thanks for the info i got it off yesterday and found i had a bad gasket anyways. i found oil puddled up right where i couldnt see it way in the back and not visable from the bores
lol so far every part ive changed or modded needed fixed or replaced anyways
BTW where can i get the rubber seals... i really want to avoid putting the cork seal at the front and back of the manifold
Thanks
|
J and J Auto
GenII
6/23/2004
09:00:29
| RE: Intake manifold torque specs
IP: Logged
Message:
get your gaskets from mopar, they cost a little
more but are better quility than aftermarket
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
