| From | Message |
FastDak4x4
Dodge Dakota
JOIN HERE
6/18/2004
19:19:14
|
 Subject: Jet Stage 2 placement
IP: Logged
Message:
Where do I put my jet stage 2 chip? I just bought one off ebay, and it has arrived.
|
Flamerdak
Dodge Dakota
JOIN HERE
6/18/2004
22:01:00
| RE: Jet Stage 2 placement
IP: Logged
Message:
It goes on your engine computer. Looking at the engine, its on your left hand side, right above the fender well. I believe it goes on the farthest connector (closest to the firewall). It will only fit into one. Since all the connctors are different. make sure your disconnect the neg side from the battery. Undo the plug, install Jet, then put the plug in the jet. Start the truck. Let it idle for a minute or so. Turn it off, then to "on", dont try to start it again. Let it stay in the "run" position for one minute. Turn it off, then restart. Enjoy!!!!!!
|
another mark
Dodge Dakota
JOIN HERE
6/18/2004
22:06:18
| RE: Jet Stage 2 placement
IP: Logged
Message:
I owned one, it does go on the connector closest to the firewall. I never did any of that turn the engine on and off and wait a minute routine. I just plugged it in and started it and drove it and it ran fine.
|
J and J Auto
GenII
6/19/2004
10:58:45
| RE: Jet Stage 2 placement
IP: Logged
Message:
No need to do anything except disconect batt to
plug it in.
The chips are vehicle specific hope you got the
right one for your truck.
Give it 200 miles to learn, they give you a little
better low end and more snap around 2500 to 3000
rpm, and help shifting points.
They will also help gas mileage 1 to 3 mpg
closest to fire wall black I beleve and yes it
will not plug into the wrong place
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
