| From | Message |
daddio
Dodge Dakota
JOIN HERE
5/19/2012
16:59:42
|
 Subject: RE: Fuel Filter Replacement
IP: Logged
Message:
The fuel filter is in the tank mounted on the fuel pump. Some say it's easier to remove the bed of the truck than dropping the tank. Especially if the tank is full.
May I ask as question of you? Why do you think you need to change the fuel filter?
|
Sharon
Dodge Dakota
JOIN HERE
5/19/2012
21:09:37
|  RE: Fuel Filter Replacement
IP: Logged
Message:
The pump is not working. When, you turn the igination on there is no noise. Nothing is working in the fuel tank.
|
daddio
Dodge Dakota
JOIN HERE
5/19/2012
21:45:40
| RE: Fuel Filter Replacement
IP: Logged
Message:
I'm assuming that your truck does not start? I've got an '00 w/ 150K miles and I never here the pump. The pump, sending unit, filter and pressure regulator are sold as a complet assy.
|
Sharon
Dodge Dakota
JOIN HERE
5/19/2012
22:17:48
| RE: Fuel Filter Replacement
IP: Logged
Message:
What would be the cost of Assembly?
How hard, would it be to put in?
|
daddio
Dodge Dakota
JOIN HERE
5/20/2012
09:10:22
| RE: Fuel Filter Replacement
IP: Logged
Message:
For cost check Autozone, Adavance Auto or RockAuto.com.
As far as how hard it is to change? That depends on your skill level. Knowing my skills, it's relatively easy. I'd suggest you get some kind of manual,Chiltons or such and read the procedure on how to do it.
Again I ask, Does your truck start/run?
|
Ralph
Dodge Dakota
JOIN HERE
5/25/2012
17:38:36
| RE: Fuel Filter Replacement
IP: Logged
Message:
Cut a hole in the bed, then put hinges on the piece you cut out. Makes the job easy!
|
cp
Dodge Dakota
JOIN HERE
7/06/2012
23:29:30
| RE: Fuel Filter Replacement
IP: Logged
Message:
The fuel pressure regulator is also in the
tank and every time it relieves pressure it
backflushes the filter. Chrysler says its
lifetime. My whole pump assm cost 400$
canadian, plus tax!! aftermarket,
replaced rusty straps too 60$ need fuel
line quik disconnect tool, and tool to
unscrew the big plastic pump assembly
retaining ring (plastic tank), otherwise is
very easy to change, just clean out the
junk that has settled on the bottom of
the tank.
|
| | <<Original Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
