| From | Message |
billm
Dodge Dakota
JOIN HERE
4/19/2004
14:28:17
|
 Subject: IAC Question
IP: Logged
Message:
I need to clean the IAC on my 95 3.9 cc. I've seen post that say don't twist or pull very hard on the IAC, or it may damage. Without meaning to sound like a smarta--, how do you get it off the throttlebody without pulling or twisting? Is there a place on the inside of the TB to push the unit out? Please help.
|
badassdak
Dodge Dakota
JOIN HERE
4/19/2004
14:33:54
|  RE: IAC Question
IP: Logged
Message:
Well I don't know about on a 95... but on my 97 there are 2 mounting screws that hold it in place... then it just comes right off. That is mine though... someone correct me if i am wrong
|
J and J Auto
GenII
4/19/2004
15:07:13
| RE: IAC Question
IP: Logged
Message:
Back of throttle body 2 #20 or 25 torx
Not removing after its out do not push pull or
twist on the plunger also check the seat that it
closes on for carbon build up
spray with carb cleaner and whipe dry gently put
a little oil on the o ring and reinstal
The plunger moves back and forth off the seat to
maintain the corect idle speed by controling
the air into the intake while plates are closed
IAC idle air control
Larry
J&J Auto
|
billm
Dodge Dakota
JOIN HERE
4/19/2004
15:41:33
|  RE: IAC Question
IP: Logged
Message:
Thanks for the replies. I'll give it a try.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
