Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
23:47:02 - 12/19/2024

V6 Dakotas
FromMessage
ccman
Dodge Dakota
JOIN HERE


4/16/2004
23:40:16

Subject: Q for Larry
IP: Logged

Message:
Sorry to keep bugging you. I opened the gap on the AP3923's from 40 to 45 like you suggested and also set the TPS just slightly over .7 volts. I've got a slight ping again and the truck does not feel as powerful probly cause its relearning the tps. would opening the gap make a hotter burn or is it opposite? should i put them back to 40? just a recap.... crank sensor mod, 180 thermo, brass cap & rotor, K&N drp in. I need your expertise. thanks Larry



J and J Auto
GenII
 Email User Profile


4/18/2004
00:43:03

RE: Q for Larry
IP: Logged

Message:
If the ping started from changing the gap yes try
going back to .040

Yes plugs are strage animals

small gap hot spark, opening will decrease the
intensity to a point than it will start to heat
up again the farther you open it.

Every truck is a little differant and if .040
runs good with no ping stay there

The TPS change will not create a ping

You can also try 1 grade higher fuel, most of the
trucks we work on run reg but some do develope a
ping and are runnin mid range

Only a few running premium but they are modded
very heavy

Larry
J&J Auto

J and J Auto
GenII
 Email User Profile


4/18/2004
00:45:10

RE: Q for Larry
IP: Logged

Message:
I was going to say do what ever you can to keep
the timming it helps across the entire rpm range
but is most noticeable better low end and gas mileage

Larry
J&J Auto

ccman
Dodge Dakota
JOIN HERE


4/18/2004
13:11:07

RE: Q for Larry
IP: Logged

Message:
defineately without a doubt!! the timing advance was the best mod yet! i was not looking for quarter mile increases or off the line. I was looking for exactly what this mod did, much much better low end, about the same at top end, don't have to accelerate nearly as hard to get any power out of the next gear. I was thinking about putting a notch in the sensor bracket so that it clears just a little more inside the bell housing to get another 1 or 2 degress. But i know nothing about this. What do you think Larry. Will I have to do anything more if I advance more? thankyou for your continued help and responses.



cjski
Dodge Dakota
JOIN HERE
 Email

4/18/2004
18:07:22

RE: Q for Larry
IP: Logged

Message:
the truck will definitely ping if when you pull the 'tps' out you don't preload the tab when you re-install it...
chris



ccman
Dodge Dakota
JOIN HERE


4/19/2004
00:30:00

RE: Q for Larry
IP: Logged

Message:
i dont think you can line up the holes to fasten it unless you preload the tab, at least on the 2002's, what year do you have?



justin
Dodge Dakota
JOIN HERE


4/19/2004
00:51:11

RE: Q for Larry
IP: Logged

Message:
yea im going to need help i went over to the s-10forum.com and i told them that my dakota smoked there extreme and there now saying that all dakotas r pieces of crap and would never hold up in a race someone go to the web site and prove them wrong please



GB2000
GenIII
 User Profile


4/19/2004
04:09:52

RE: Q for Larry
IP: Logged

Message:
Dude...why do that sh!t? It drives us nuts when some extreme lover comes over here bragging about how he could kick all our asses with his truck and you're doing the same thing to them.

Josh

Red 98 RC V6 2wd Single in/dual out exhaust (soon to be switched to a flowmaster 40 single in/dual out), Edelbrock 10" round air cleaner w/ K&N air filter, Autolite AP3923s, 180*F Thermostat, Ported V6 throttle body ...and much more to come!

   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.