| From | Message |
boguspete
Dodge Dakota
JOIN HERE
4/15/2004
22:55:50
|
 Subject: Codes or lack of 'em?
IP: Logged
Message:
Anyone -
I've got a check engine light on, no noticeable probs.
Took it to 'Zone, they couldn't get a connection with the computer. It was like the computer refused to link with it. We tried the scanner on another vehicle, and no probs......
Maybe computer fubar'd?
Any ideas?
Chris
btw, 98 v6 5sp - iat relocate, app plugs, k&n
|
J and J Auto
GenII
4/15/2004
23:00:52
|  RE: Codes or lack of 'em?
IP: Logged
Message:
tighten your gas cap once and check it they
go bad or are left lose and they will trow a code
small leak on evap system
Larry
J&J Auto
|
boguspete
Dodge Dakota
JOIN HERE
4/15/2004
23:47:05
| RE: Codes or lack of 'em?
IP: Logged
Message:
thought of that right off the bat......
Why wouldn't the hookup be able to communicate with the computer?
said something like "unable to establish a link" on the 'Zone scanner. ??????
|
bump
Dodge Dakota
JOIN HERE
4/16/2004
09:09:31
|  RE: Codes or lack of 'em?
IP: Logged
Message:
" dirty " connector ?
Problem could have something to do with
your IAT relocate ?
Try resetting computer ( undo negative batt cable
key on for a few seconds then reconnect )
How long before light back on , if at all ??
|
FryZss
Dodge Dakota
JOIN HERE
4/16/2004
12:00:29
|  RE: Codes or lack of 'em?
IP: Logged
Message:
I got a check engine light so I hooked up a Innova 3100 scanner from Kragen with no problem.
It gave a code of P0304. This code says misfire detected at #4 plug. I never felt or noticed any sort of problem. Can't explain why you can't read codes though. If someone has a factory manual maybe they can give the pin layout to check them.
Jeff
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
