| From | Message |
slow97dakota
Dodge Dakota
JOIN HERE
2/16/2004
12:17:57
|
 Subject: intake manifold HELP!
IP: Logged
Message:
im tryin to mod my intake but i have no fing clue on what im doin. i looked at the hughes site but when they say 12 inches or 14 inches, where do u measure from? and do u takje the divider out? can sum 1 walk me threw this please?
|
Steve Baldwin
Dodge Dakota
JOIN HERE
2/16/2004
13:08:07
|  RE: intake manifold HELP!
IP: Logged
Message:
I have a modified Intake manifold. Here is what was done to it.
1. the Throttle Body ports were enlarged to accept the larger ports of the V8 TB.
2. the Center divider was cut way back.
3. the exhaust ports were widened to match the ports on the head.
4. As for the runners, Only have them cut back if you are running NOS or a super charger. I did have mine cut 1/2 inch back and also polished on the inside of the runners.
5. the fuel injector ports were raidused out.
I kept my origional intake so I can try doing one myself.
|
slow97dakota
Dodge Dakota
JOIN HERE
2/16/2004
19:55:27
| RE: intake manifold HELP!
IP: Logged
Message:
thanks, but um can u maybe elaberate alittle more, i am running nitrous. what should i open the bores up 2? when u say radioused out do u mean just like cleaned up or what? and for the exhaust port are u talkin about gasket matching the ports?
|
J and J Auto
GenII
2/16/2004
22:16:38
| RE: intake manifold HELP!
IP: Logged
Message:
Radious around injector holes like a taper
mesure from where the gaskit sits all the way
through to the inside opening of the runner and
match the intake ports by the gasket to the port
on the heads
You do not need to open the bores to 50mm unless
your going very hot cam and heads
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
