| From | Message |
92Dakota
Dodge Dakota
JOIN HERE
2/11/2004
23:36:10
|
 Subject: Larry
IP: Logged
Message:
I remember you saying that you installed many roller rockers on 3.9 V6's.
Do you have any used ones in good condition?
(1.7's)
I really want to try the mod, but $350 is a little steep right now.
|
another mark
Dodge Dakota
JOIN HERE
2/12/2004
01:14:51
| RE: Larry
IP: Logged
Message:
In the performance forum there is a group buy going on for Harland Sharp roller rockers for $260.
|
J and J Auto
GenII
 
2/12/2004
01:30:19
| RE: Larry
IP: Logged
Message:
The only set I have laying around are going back
in the stock motor I am running as soon as crower
sends me the 1 I ordered to replace the 1 I blew
about a week ago.
It was a motor out of a rolled 92 Dak the guy put
them in wrong did not adjust right
I am waiting on some 10.5 to 1 pistons for my
stroked V6 than it will be going back in my truck
The mopar 1.7's are also about $250 extruded alm
All the ones I installed are still out there
running strong
Larry
J&J Auto
|
92Dakota
Dodge Dakota
JOIN HERE
2/12/2004
02:13:25
| RE: Larry
IP: Logged
Message:
Oh okay.
Do you recommend the Mopar ones? Or just get the Crowers?
What do you mean by not adjusting them right? What is it that has to be precise?
|
92Dakota
Dodge Dakota
JOIN HERE
2/12/2004
02:23:56
| RE: Larry
IP: Logged
Message:
Whats your opinion on the Harlands?
|
J and J Auto
GenII
2/12/2004
21:29:54
| RE: Larry
IP: Logged
Message:
My pesonal opinion is the good strong crowers
but there are a lot of guys running the mopar
units with no problems
Never seen or used the harlands so I could not say
Larry
J&J Auto
|
Wadak
Dodge Dakota
JOIN HERE
2/13/2004
05:43:21
| RE: Larry
IP: Logged
Message:
I see where some from southeastern rt is offering a group buy on the Harland Sharps for the v6 on the General Dak board.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
