| From | Message |
Darryl
Dodge Dakota
JOIN HERE
2/10/2004
13:40:26
|
 Subject: ? 4 LARRY.....
IP: Logged
Message:
Hey Larry, I want to make sure that I gave my friend the right answer.
He did the IAT relocate (99 V6) and wasn't sure of his wire splicing/connection. I told him that if the wires were not spliced correctly(open circuit) than the "check engine" light would come on.
Is this correct? Or would it just store a code without the "check engine" coming on?
I'm pretty sure the light would illuminate so I hope I told him correct!
Thanks,
Darryl
|
J and J Auto
GenII
 
2/10/2004
17:26:49
|  RE: ? 4 LARRY.....
IP: Logged
Message:
It does not mater which wire goes to which side
it will still read the resistance that changes
with heat.
IAT is just a varible resistor that changes
resistance with heat to change the voltage the
comp reads 1 to 4.8 volts over or under will
throw a code
Larry
J&J Auto
|
Darryl
Dodge Dakota
JOIN HERE
2/10/2004
18:19:59
| RE: ? 4 LARRY.....
IP: Logged
Message:
Throw a code; as in illuminate "check engine" light or just store a code and NOT illuminate "check engine' light??
Darryl
|
whitedakota2
Dodge Dakota
JOIN HERE
2/10/2004
19:33:17
| RE: ? 4 LARRY.....
IP: Logged
Message:
You'll get a light and a code.
|
Darryl
Dodge Dakota
JOIN HERE
2/10/2004
21:01:37
| RE: ? 4 LARRY.....
IP: Logged
Message:
Thanks Whitedakota2
Darryl
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
