| From | Message |
reddak95
Dodge Dakota
JOIN HERE
2/11/2002
10:15:15
|
 Subject: O2 Sensor
IP: Logged
Message:
Any suggestions on replacing a 02 sensor on a 95 3.9 v6. Do I need a special socket?
Thanks for the help.
|
bernd
*GenIII*
2/11/2002
10:45:38
| RE: O2 Sensor
IP: Logged
Message:
You can use either a big crescent wrench, a 7/8" box-end (remove the connector first), or an O2 sensor socket. If it's been on there for quite some time, be careful not to bust your knuckles when pulling it off.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
Jim Wolfe
Dodge Dakota
JOIN HERE
7/07/2005
17:32:10
| RE: O2 Sensor
IP: Logged
Message:
I need to replace my O2 sensor but am not sure which it it.The # is PO132.Is this the one before or after the catalytic convertor.Thanx for your help.
|
schmidtmike
Dodge Dakota
JOIN HERE
7/09/2005
15:11:56
| RE: O2 Sensor
IP: Logged
Message:
A 7/8 combination wrench will work to remove the old O2 sensor, but because of the connectors bulk, it will not clear the inside of the box end wrench, so you will have to cut the connector off. And believe me, using an open end wrench is almost a guaranteed purchase of a new Y-Pipe, because you stripped the O2 sensor. Buy the O2 sensor socket, it's not a gimmick, and is worth the saved frustration
|
01dak
Dodge Dakota
JOIN HERE
7/10/2005
16:28:25
| RE: O2 Sensor
IP: Logged
Message:
Is there a way of knowing which sensor is bad? My truck brings up the code p 0152, I looked up what it meant on allpar.com and it says "Oxygen sensor voltage problem" I really don't want to buy them both if I can help it. Any advice???????
|
xmr
GenIII
7/10/2005
22:51:15
| RE: O2 Sensor
IP: Logged
Message:
The front sensor is the one that manaages your fuel mixture the one after the cat just tells the computer that the cat is working. If you replace the front 02 and still get the 0152 code then the back o2 sensor is not working or the cat is not working.
'98 cc auto /Home brew cold air with K&N,Dynomax, Superchip Tuner, 1.7 RR,, F&B tb. NAPA cap and rotor, 3923 plugs,tps mod,relocated & switchable iat, 180 t'stat, Crankshaft sensor mod.,PVI,Ported and Polished manifold, bosch injectors,Black Magic Elec Fan, msd wiires
|
schmidtmike
Dodge Dakota
JOIN HERE
7/11/2005
18:15:19
| RE: O2 Sensor
IP: Logged
Message:
01Dak, i have a feeling that your O2 sensor is not the culprit, it is the wire going from the battery to the O2 sensor. You're going to have to find the wire that goes to the O2 sensor with +12 volts going to it, and run a jumper wire from that directly to the postive lead on the battery, because the power wire has shorted out somewhere between the O2 sensor and the positive lead on the battery.
|
01Dak
Dodge Dakota
JOIN HERE
7/13/2005
13:05:23
| RE: O2 Sensor
IP: Logged
Message:
Thanks for the help. I guess i'll check the wires first and hopefully that will fix it.
|
Dan M
Dodge Dakota
JOIN HERE
7/13/2005
13:22:42
| RE: O2 Sensor
IP: Logged
Message:
When I replaced the O2 sensor in my 95, I used an open end wrench and did not have any problems.
- Dan M
|
214
Dodge Dakota
JOIN HERE
7/13/2005
14:34:08
| RE: O2 Sensor
IP: Logged
Message:
Where do you get an O2 sensor wrench at, is it expensive?
|
Bob Lincoln
Dodge Dakota
JOIN HERE
7/13/2005
15:35:12
| RE: O2 Sensor
IP: Logged
Message:
Autozone, rent or buy for $15.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
