| From | Message |
dazed
Dodge Dakota
JOIN HERE
1/25/2004
22:29:07
|
 Subject: 1990 Dak
IP: Logged
Message:
have a problem with my truck stalling. will be running fine then just stall but will fire back up and go, if im at a light or stopped it starts after alot of cranking. fuel system ok, was checked. only codes given is 11. 21. 34. 52. no check engine light. main/reqd light been on since owned. had O2 sensor checked told working ok. please anyone with some knowlege of the possable problem reply. I dont know alot about the computer sensors, or compuetr itself so any help will be put to use. thanks all.
|
Trevor Pauls
Dodge Dakota
JOIN HERE
6/06/2005
07:50:18
|  RE: 1990 Dak
IP: Logged
Message:
I have a problem with my '90 dodge dakota v6. the problem is that when i try to get up to highway speed (step on the gas) or increase my rpms, my truck sputters, coughs, and misses, but as soon as i let off the gas it ok. i can rev at about 2300 before this happens. The wierd thing is this only happens when the vehicle is warm and if ur driving and put it neutral, shut the key off, start it back off, and start driving again its fine for another couple minutes. everything to do with spark, distributor, and fuel has been checked and replaced as necessary. my next course of action is to replace the computer. however if anyone out there has suggestions i'd be more than happy to here from u. thanx.
|
dodgedakota90
Dodge Dakota
JOIN HERE
6/06/2005
23:54:40
|  RE: 1990 Dak
IP: Logged
Message:
i have a 90 dodge dakota, and when i bought the truck, it did the same thing, maybe not as bad as you, but i change spark plugs and it seems t be doing fine now..
if anyone wants to chat on AIM my S/N is dodgedakota9004
|
Super-bee
Dodge Dakota
JOIN HERE
6/08/2005
12:33:10
| RE: 1990 Dak
IP: Logged
Message:
swap a 318 into it, thats how im fixing my 1990 v-6 :)
|
JB
Dodge Dakota
JOIN HERE
6/08/2005
16:02:48
| RE: 1990 Dak
IP: Logged
Message:
Dazed and Trevor...don't replace the computer yet! That is way too expensive and probably not necessary.
For Dazed: Try the hall effects pick up. It is a little black disk inside the distributor under the rotor and seems to play a big part in Mopar products stalling intermittently. Do you have a repair manual? I'll give you the explanations of your fault codes when I get home tonight if not. Also, who checked the fuel system and what did they check, it doesn't sound like you've been to the dealer.
For Trevor: My best guess for your problem is the EGR valve. This is a heat sensitive part that if not operating properly can cause those symptoms and even stalling. (I didn't say this to dazed because he didn't say it's related to heat) In any case get the valve checked or if you know it's been 50,000 since it was replaced get a new one...from the dealer. The aftermarket ones do not work! The factory unit is drilled for your specfic engine, the aftermarket ones come with a set of washers to change the diameter of the hole depending on what kind of vehicle you have.
|
Three.9HP
Dodge Dakota
JOIN HERE
6/17/2005
11:33:23
| RE: 1990 Dak
IP: Logged
Message:
Try the distrbutor gear and bushing. I had the same problem with mine.
|
bathbrian
Dodge Dakota
JOIN HERE
10/28/2010
07:24:15
| RE: 1990 Dak
IP: Logged
Message:
Same problem....1990 dakota v6 ....changed everything and
still problems ..... finally listen to my dad and went and got
the battery tested ..... bad battery .... changed the battery
and now truck runs like a champ again
|
Alan
Dodge Dakota
JOIN HERE
2/27/2012
18:16:21
| RE: 1990 Dak
IP: Logged
Message:
I have a 1990 dodge dakota that stalls when warm, usually 20 min. after starting. I have replaced the engine control module, plugs, plug wires, coil,the ignition pick up in the distributor without any improvement. What should I do next?
|
Bob Lincoln
Dodge Dakota
JOIN HERE
2/28/2012
09:04:38
| RE: 1990 Dak
IP: Logged
Message:
Check fault codes. Check the splice near the relay box.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
