| From | Message |
brentsdakota
Dodge Dakota
JOIN HERE
1/07/2004
16:30:07
|
 Subject: FIPK support shaft snapped in T.B.
IP: Logged
Message:
I have a K&N FIPK on the Dakota and the support shaft snapped inside the throttle body. My question is can this be removed or should I just do the throttle body replacement with a V8, Fastman or F&B. The truck is a '96 3.9 with no other mods. By the way is there any harm with no air filter until I get the new one installed?
If money was no object what throttle body will work best and what MM. Thanks, Brent
|
dakotadude
Dodge Dakota
JOIN HERE
1/07/2004
18:09:15
|  RE: FIPK support shaft snapped in T.B.
IP: Logged
Message:
I have the FIPK as well and I hope it doesn't snap as yours did. Good luck.
|
scottB
Dodge Dakota
JOIN HERE
1/07/2004
18:41:04
| RE: FIPK support shaft snapped in T.B.
IP: Logged
Message:
I'm new to the board and was also wondering where you could buy a new throttle body.
|
dakguy
Dodge Dakota
JOIN HERE
1/08/2004
10:33:08
| RE: FIPK support shaft snapped in T.B.
IP: Logged
Message:
Have you tried a drill out?
|
b1llyw
GenII
1/08/2004
10:52:59
| RE: FIPK support shaft snapped in T.B.
IP: Logged
Message:
I would try a drill-out, easy-out etc. first. I would avoid driving with no air-filter. You don't know what you're going to suck into the engine. If you want to go aftermarket, an F&B 48mm works well on a stock V6.
Bill White - KRC Performance
'95 CC 4x2, SLT - 408 is done, truck isn't
'03 Ram 1500 QC 4x4 Hemi Off-Road
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
