Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
00:02:10 - 12/20/2024

V6 Dakotas


























































































































































FromMessage
Big John
Dodge Dakota
JOIN HERE


8/07/2003
07:14:38

Subject: Codes
IP: Logged

Message:
How do I read the codes on a '94 SLT? Thanks in advance.



J and J Auto
Dodge Dakota
JOIN HERE
 Email

8/07/2003
11:32:04

RE: Codes
IP: Logged

Message:
Turn the key on off, on off, on off 3 times than
turn it on and watch the check engine light.

1 pause 2 flases is 12 start of diagnostic's

you can find all the codes here

http://autorepair.about.com/library/ts/obd-i/bl-dtcs-55a.htm


 12 

Battery input to PCM disconnected during last 50 key starts.

 13 

MAP sensor pneumatic circuit.

 14 

MAP sensor electrical circuit.

 15 

Vehicle speed/distance sensor.

 16 

Open or shorted condition detected in knock sensor circuit.

 17 

Engine running too cool.

 21 

Oxygen sensor circuit.

 22 

Coolant temperature sensor circuit.

 23 

Intake air temp. sensor voltage high.

 24 

Throttle position sensor.

 25 

IAC motor driven circuit.

 27 

Fault in injector driver interface circuit.

 31 

Purge solenoid circuit.

 32 

Fault in EGR diagnostics.

 34 

Speed control solenoid circuits.

 33 

A/C cutout relay circuit.

 35 

Fan control relay circuit.

 41 

Charging system excess or no field current.

 42 

ASD relay circuit.

 43 

Fault in ignition coil control circuit.

 44 

Battery Temp Voltage.

 46 

Battery voltage too high.

 47 

Battery voltage too low.

 51 

Oxygen feedback system stuck at lean position.

 52 

Oxygen feedback system stuck at rich position.

 53 

Internal logic module problems.

 54 

No cam position signal.

 55 

Completion of fault code display.

 62 

Indicates unsuccessful attempt to update EMR mileage.

 63 

Unsuccessful attempt to write to an EEPROM location by the controller.

 64 

Methanol sensor voltage too low.





To call up codes, cycle ignition switch on, off, on, off and on within 5 seconds. Stored codes will be indicated by flashes of the power loss/check engine lamp. The codes will be indicated as two digit numbers, with a four second pause between codes. An example of a code is as follows:






   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.