| From | Message |
90daknthe12s
Dodge Dakota
JOIN HERE
8/03/2003
14:48:40
|
 Subject: troubleshooting gen 1
IP: Logged
Message:
ok i have a 90dak with a 3.9 and i just bout a new ecm for it i was wondering what are the possible causis of a code 11 no crank refrence i already replaced the hallefect sensor and timed the distributor but all im getting is inttermintent start and it wont run longer than a few minuts ne help with this matter will be greatly appreiciated
|
Rooster
Dodge Dakota
JOIN HERE
8/03/2003
19:49:51
|  RE: troubleshooting gen 1
IP: Logged
Message:
sounds like a bad ground through the ECM... This could cause a complete ECM fail ne ways. See if you have a bad ground sometimes an ECM will try and ground through the hot wires.
There might also be a problem with your pickup. This is a lil thing at the bottom of the distib.
A bad coil is also possible.... Make sure you coil is not hooked up backwards.
|
90daknthe12s
Dodge Dakota
JOIN HERE
8/03/2003
21:06:35
| RE: troubleshooting gen 1
IP: Logged
Message:
would that cause a intemintent start amd constantly running for a set time say 30-45 seconds because it will start occasionaly and run a littl bit then just shut off
|
Rooster
Dodge Dakota
JOIN HERE
8/04/2003
00:51:06
| RE: troubleshooting gen 1
IP: Logged
Message:
what part of my game plan are you asking about?
|
HENRY
Dodge Dakota
JOIN HERE
9/08/2003
20:56:05
|  TROUBLE SHOOTING ABS
IP: Logged
Message:
I HAVE A 1998 DODGE DAKOTA WITH A ABS LIGN AND A BRAKE LIGHT ON.IS THERE ANYWAY TO GET THE FAULT CODES FROM ONBOARD .I DONT HAVE A SCANNER OR ANYTHING ELSE. IF ANY HELP OUT THER EMAIL ME AT HOBOKENKD@AOL.COM THANKS
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
