| From | Message |
Joe
Dodge Dakota
JOIN HERE
7/26/2003
21:56:03
|
 Subject: Fault codes
IP: Logged
Message:
I got bored today and decided to check some codes. I finally found out how in the Haynes manuel. I flipped the key twice then left at on position. The light stayed on a sec, then
3 flashes, pause, 5 flashes, pause, 5 flashes. In the Haynes it say it will flash eight times signaling the start. Didnt do that. Then I look up the pattern I got and there isnt one. It also says the end code is 5 flashes, pause, 5 flashes. So that leaves me with no start code, 3 flashes, and an end codes. No code for 3 flashes. Im also assuming that the stored codes are not severe and wont light the check engine lite, but only severe problems will. Ive never dealt with this.
|
just me
Dodge Dakota
JOIN HERE
7/27/2003
10:20:10
| RE: Fault codes
IP: Logged
Message:
didja ever stop to think that Hayes just might be a bit WRONG?
|
Joe
Dodge Dakota
JOIN HERE
7/27/2003
22:51:38
| RE: Fault codes
IP: Logged
Message:
Im not sure where to look to find out how to decode this. If the Haynes is wrong, should I invest in a Chilton or factory manual. Id rather not. Does anyone know what this code means or know of any way to find out,Id appreciate it.
|
JJ
Dodge Dakota
JOIN HERE
7/28/2003
06:59:38
|  RE: Fault codes
IP: Logged
Message:
http://dakota-truck.net/CODES/codes.html
|
Joe
Dodge Dakota
JOIN HERE
7/28/2003
09:42:31
| RE: Fault codes
IP: Logged
Message:
Thanks JJ. I guess I'll try it again since it says all codes are two digits.
|
Shank
GenII
7/28/2003
16:35:06
|  RE: Fault codes
IP: Logged
Message:
The 3 you are referring to is/was actually 1 & 2. which means power loss in last 50-100 start-ups. 55 is end of test. No fault codes, everything is OK.
If it don't work hit it with a hammer, Still don't werk? GET A BIGGER HAMMER!
|
just me
Dodge Dakota
JOIN HERE
7/28/2003
17:06:58
| RE: Fault codes
IP: Logged
Message:
guess I was a bit wrong, good catch Shank!
|
Joe
Dodge Dakota
JOIN HERE
7/28/2003
17:10:19
| RE: Fault codes
IP: Logged
Message:
Thanks Shank. Im putting new rotors on right now $70 for both from auto zone. I'll go ahead and put new bearings in since my neighbor suggested it. He's a Dakota driver too!
|
Shank
GenII
7/29/2003
20:55:20
| RE: Fault codes
IP: Logged
Message:
;) Just trying to help.
Bookmark this site for future references, it's not all inclusive but it helps...
http://www.minimopar.net/fault/index.html
If it don't work hit it with a hammer, Still don't werk? GET A BIGGER HAMMER!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
