| From | Message |
Lloyd
Dodge Dakota
JOIN HERE
6/09/2003
21:30:39
|
 Subject: Low washer level light
IP: Logged
Message:
ON MY 92 the wiper washer fluid light stays on even tho the reservoir is full, I can disconnect the 2 wire plug and the light goes out. is this sensor replacable or do I have to replace the whole reservoir pump and all?
Lloyd
|
marlow
Dodge Dakota
JOIN HERE
6/09/2003
23:50:50
|  RE: Low washer level light
IP: Logged
Message:
check your blinker fluid...
|
Lloyd S Smith
Dodge Dakota
JOIN HERE
6/10/2003
15:21:58
|  RE: Low washer level light
IP: Logged
Message:
check what??? is this a smart assed reply? or what?
|
TerryS
Dodge Dakota
JOIN HERE
6/10/2003
16:11:13
| RE: Low washer level light
IP: Logged
Message:
My 88 would constantly do the same thing. A good wack on top of the sensor would usually unstick it for a while, but it always came back. I figured that the current was too high for the contacts, so they were welding themselves together, thus sticking in the "low fluid" condition. I never bothered to replace mine, figuring it was a design problem and the new one would do the same thing, but I haven't seen many other complaints here, so maybe its fairly rare, and a new sensor would cure it....
I added a transistor to the circuit to lower the current that the contacts had to switch. That cured the problem permanently.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
