| From | Message |
ALEX WRIGHT
Dodge Dakota
JOIN HERE
1/29/2003
13:02:00
|
 Subject: CUSTOM CAM
IP: Logged
Message:
HAS ANYONE EVER CHECKED INTO DOING A RE-GRIND ON A FACTORY CAM YET? I HAVE BEEN THINING ABOUT IT...
|
dodgeboy
Dodge Dakota
JOIN HERE
1/29/2003
14:49:13
|  RE: CUSTOM CAM
IP: Logged
Message:
I have one...any cam company will do them..mines from comp cams
|
rtdkota
R/T
1/29/2003
17:10:48
| RE: CUSTOM CAM
IP: Logged
Message:
I get cams done by Crower-- custom grind based on your modifications and or specs.
You'll need longer pushrods, roller rockers are also a good idea.
I can set you up.
Sam
www.socaldakota.com
RTDKOTA
|
Brian Maier
Dodge Dakota
JOIN HERE
1/29/2003
19:34:55
| RE: CUSTOM CAM
IP: Logged
Message:
RTDkota can you do a custom grind cam and 1.7 roller rockers? A lot of places i have seen say that if you do a new cam to stick with the 1.6 RR's. Is it a space issue or lousy perfomance issue, or neither?
Thanks
Brian
|
RTDKOTA
R/T
1/30/2003
02:31:50
| RE: CUSTOM CAM
IP: Logged
Message:
Crower did a custom cam for me based on the 1.7s I already had (Crower). There's two ways of doing it-- Go with 1.6s, and have the cam ground based on using 1.6s, or go 1.7s on the stock cam... You CAN do 1.7s on a cam, as long as your lift isn't too radical. I run an effective .512/.512 lift (based on the 1.7 ratio)... and the truck runs excellent (this is with a 5.9L, 3.9L would of course be a different grind.)
Sam
www.socaldakota.com
RTDKOTA
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
