Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
23:00:07 - 12/19/2024

V6 Dakotas
FromMessage
Steve
Dodge Dakota
JOIN HERE
 Email

1/24/2003
02:40:36

Subject: 01 3.9-couple of concerns
IP: Logged

Message:
Current outside air temp is 0F and has been for a week now. 2001 SLT CC 3.9 A/T 24 000 miles

1) When I start the truck the oil pressure gauge doesn't move for a good 8-10 seconds. Then it just shoots up to the second notch and stays there. The needle falls to half way when the engine heats up. I'm running Mobil 1 10W30 and a Delco PF13C filter. Level is good. There's no bad sounds associated with it like lifters or any kind of bearing knock.

2) Last night the transmission would not shift into O/D. Even after the truck had run on the highway for 20 minutes and was nice and warm. I tried slowing down to 30MPH then tromping it to get the kick down. I finally pulled off, shut her down, started up right away and drove off. It was fine after that.

3) I have a real big problem with pinging. Steady cruise and acceleration cause all sorts of pinging. I'm running the Autolite 3923's and 87 shyte octane gasoline. I'll switch to a 180F t-stat as soon as the weather warms up a bit. I'll prolly do cap, rotor and wores then. Any recommendations for the last three? ANy other tips?

TIA

Steve



DakotaDan
*GenIII*
 Email User Profile


1/24/2003
07:15:50

RE: 01 3.9-couple of concerns
IP: Logged

Message:
1. I use Mobil 1 5w30 in the winter 10w30 summer

2. The transmission has a temperature sensor in it that won't allow it to shift into OD until it reaches a certain temp. keeps the trenny from slipping.

3.I have tried the Autolites & a 180* thermostat and my truck ran worst with them so I changed back to stock plugs & stat. With 24k miles I would say your on the right track changing the cap & rotor

Dan

Next Time You Think You're Perfect
~~~~~Try Walking On Water~~~~~

Dukie57
Dodge Dakota
JOIN HERE
 Email

1/24/2003
09:56:45

RE: 01 3.9-couple of concerns
IP: Logged

Message:
I run nothing but 89 octane in my 01 3.9V6. Since I started doing that, I've not heard the truck ping once. With 87 it would ping under heavy acceleration. I believe I read something that came with the truck that you should run 89 octane anyways.




   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.