| From | Message |
Ryan33
Dodge Dakota
JOIN HERE
1/14/2003
02:25:49
|
 Subject: Installed RR's Need Help!
IP: Logged
Message:
Am I supposed to reset the computer after the install?? Also, when I let off the brake it is sluggish to move forward and takes a bit more effort to get it going than it did before the install?????? What do I need to do??
|
Chip B.
Dodge Dakota
JOIN HERE
1/14/2003
02:36:01
| RE: Installed RR's Need Help!
IP: Logged
Message:
The computer does not require reset. The RR change is only a small change in valve lift and won't effect it that way.
|
Lattimer
Dodge Dakota
JOIN HERE
1/14/2003
09:45:41
| RE: Installed RR's Need Help!
IP: Logged
Message:
Did you maybe knock a vacuum hose loose or something when you did the install?? I would check out all of that kind of stuff first.
|
DakotaDan
*GenIII*
1/14/2003
12:09:35
|  RE: Installed RR's Need Help!
IP: Logged
Message:
Hope you didn't tighten the lifters to tight....................and your loosing compression !!
Dan
Next Time You Think You're Perfect
~~~~~Try Walking On Water~~~~~
|
Deep Purple
Gen III
1/14/2003
12:27:59
| RE: Installed RR's Need Help!
IP: Logged
Message:
Dan's got the right idea. Go through and readjust the valves, pay close attention to the cyclinder you are working on. Be sure it is up on compression. I probably did mine two or three times.When you first start; let it idle for about ten minutes before you give it any gas. Mine still ran funky for about one thousand miles, but I changed injectors too. Good luck.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
