| From | Message |
kryp2nite
Dodge Dakota
JOIN HERE
8/25/2002
17:39:52
|
 Subject: Roller rockers
IP: Logged
Message:
ok im selling my system...
im hoping to get 300 for it
if i do what should i use it on?
intake.... TB.... will i have money left over for anyother mod?
00 Rc 239 CI
mods: muffler
by the way.. 2 12'' kicker comp's in carpeted box MTX thumder 2160 and wiring kit for $300
any takers?
|
kryp2nite
Dodge Dakota
JOIN HERE
8/25/2002
17:41:43
| RE: Roller rockers
IP: Logged
Message:
wow that mustve been misleading
i meant to ask how much RR are
and how long it took to install along with how hard to install
lol
|
DakotaDan
*GenIII*
 
8/25/2002
17:55:15
|  RE: Roller rockers
IP: Logged
Message:
http://www.crower.com/cat/domestic/chrysler/truck_valvetrain.shtml
http://www.socaldakota.com/rockers.htm
Dan
K&N FIPK # 57-1517 * DynoMax #17748
OEM 5.2/5.9 V8 TB #53032691AA * Crower 1.7 Roller Rockers # 73654K
Factory Flares * WeatherTechs * Saddleman Low Profile Tonneau
|
kryp2nite
Dodge Dakota
JOIN HERE
8/25/2002
18:07:13
| RE: Roller rockers
IP: Logged
Message:
should i opt for the ones with the plates giudes and new push rods?
or could i buy them later?
|
POWER HUNGRY
Dodge Dakota
JOIN HERE
8/25/2002
20:07:14
| RE: Roller rockers
IP: Logged
Message:
On the crower web site the guide plates, pushrods, and rocker stud are a seperate kit that they say is a must for over 5500 rpm useage. So it a depends on how much work are you going to do to your motor. I have read a lot of posts from guys with a good amount of mods that shift at rpm level below that. I would not get the rev kit right now and save your money, because the stock cpu will not let you rev that high anyway.
I would wait on getting the rev kit until after you get: a cold air intake, modifed cpu, throttle body, headers, ignition up grade and maybe modifed heads or a cam before get the rev kit. Why buy it if you don't need it?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
