Forums
Forum Tools
|
 |
23:25:33 - 12/19/2024
V6 Dakotas
| From | Message |
pbxr
GenIII
 
8/06/2002
07:40:54
|
 Subject: Exhaust Install Complete
IP: Logged
Message:
Hey all, I just installed my DynoMax muffler#17748 last night. I managed to use the stock tail pipe,note if you attempt to do this, buy a 3" 2 1/2 ID to 2 1/2 OD sleeve, and it will all fit like a glove. Maybe this was overkill, but I also bought a universal hanger for the muffler side, to add support similiar to the stock setup. One problem I notice now is a slight hesitation if I stomp on it from a stop, any thoughts on how to remedy this? Would reseting the PCM help? I like the low sound, and the fact that it does not buzz me out of the cab. I also like the sense of extra power when passing.Thanks
'01 Sport Auto 3.9, CC, 3923s, Intense Cold Intake, just installed Dynomax muffler
|
Chris
Dodge Dakota
JOIN HERE
8/06/2002
13:55:40
|  RE: Exhaust Install Complete
IP: Logged
Message:
Just got mine done too...and I like it!
Since I have a 5spd I can't address your hesitation, but wanted to chime in with the same mods.
I installed the IP power stackII first, then a few days later the 3923s & reset the computer. That's when I noticed the biggest difference in power. Today, installed the Dynomax & reset the computer again. Seems to be giving me at least 10% improvement in mpg (I burn half a tank/day commuting)over previous all stock w/Tornado air.
-Chris
'00 CC Sport+
|
pbxr
GenIII
8/06/2002
14:25:06
|  RE: Exhaust Install Complete
IP: Logged
Message:
Chris, I just reset my PCM(on my lunch, couldn't wait hehe), and the exhaust seems a tad bit louder, and the truck seems to run better/stronger. This is the first time I have reset it since I have had it. It sounds good none the less. Also the hesitation I notice is only if I floor it from a stop. If I ease on the idle it seems fine. My mods were about the same as you, plugs, waited 2 weeks intake, waited a few more weeks now muffler. The ? that looms now is whats next? I am thinking cap, wires.
'01 Sport Auto 3.9, CC, 3923s, Intense Cold Intake, just installed Dynomax muffler
|
Chris
Dodge Dakota
JOIN HERE
8/06/2002
14:46:21
|  RE: Exhaust Install Complete
IP: Logged
Message:
I hear ya...seems like now that I've started, I want more & more. I was thinking cap & wires too, but haven't ever gotten a noticible improvement from them in the past on other vehicles. From what I'm reading on the boards, TB seems to be the best bang for the $ if I continue down this path. It's more $ than I want to spend anytime soon though. I'm wondering how TB compares to chip/module with regard to performance and mpg vs $$?
-Chris
|
pbxr
GenIII
8/06/2002
15:24:17
| RE: Exhaust Install Complete
IP: Logged
Message:
TB does sound good, at least from all of the posts I hae read. It makes me want to go to my local bone yard and see if I can scavenge one.
'01 Sport Auto 3.9, CC, 3923s, Intense Cold Intake, just installed Dynomax muffler
|
Chris
Dodge Dakota
JOIN HERE
8/06/2002
15:45:05
| RE: Exhaust Install Complete
IP: Logged
Message:
Heh - was just reading more on speedtweaks.net & appears I didn't reset my PCM...just disconnected the battery (both terminals)...but will have over 200 miles by this time tomorrow. If I could only find a wrench around this place...
Also noticed that they address initial stomp-on-it-hesitation w/instructions for adjusting TPS. That's probably what you need to do if it bugs ya.
-Chris
|
pbxr
GenIII
8/07/2002
06:41:20
| RE: Exhaust Install Complete
IP: Logged
Message:
Cool, thanks Chris, I will have to check it out.
It doesnt bug me too bad, but if I can eliminate it that would be cool to. I will check it out and let you know.
'01 Sport Auto 3.9, CC, 3923s, Intense Cold Intake, just installed Dynomax muffler
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
