| From | Message |
Kent
Dodge Dakota
JOIN HERE
5/18/2002
11:57:55
|
 Subject: Volant with K&N filter?
IP: Logged
Message:
I recently baught a Volant intake to replace my Homebrew set up (I wanted a cleaner look inside the engine bay) My question is: Is the K&N 6*9 filter less restrictive then the volant filter? If so should I just put the K&N on the end off my new Volant set up?
|
NJQCDak
GenIII
5/18/2002
19:47:19
|  RE: Volant with K&N filter?
IP: Logged
Message:
Kent,
I don't know if the K&N outflows the Volant filter but if the K&N fits on the set up then use it if you like. My set up had no extra space. The filter closes to the front of the engine bay.
'01 QC Sport, 3.9L V6, 5spd, 2wd, Volant Intake,
SS Gibson exhaust, MSD Wires, Accel Super Coil, NAPA Cap, Flometrics Billet 48mm TB , JBA Silver Ceramic Headers, Autolites 3923s
|
Bernd
*GenIII*
5/18/2002
21:50:59
| RE: Volant with K&N filter?
IP: Logged
Message:
All of the cotton gauze filters flow close to the same on a comparison. None will gain you anything more than 1-2HP max (on a good day) and a larger (or smaller) dent in your pocket book.
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
low99dakota
*GenIII*
5/18/2002
21:55:53
| RE: Volant with K&N filter?
IP: Logged
Message:
Bernd, can you check your Speedtweaks email please...
99 SY RC
|
Kent
Dodge Dakota
JOIN HERE
5/19/2002
00:23:13
| RE: Volant with K&N filter?
IP: Logged
Message:
Ok, I kinda liked the looks of the volant with the blue anyway. Bernd, on a side note my new throttle body was recieved and the transplant went extremely well! I noticed more power right away; even before the full PCM re-learn.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
