| From | Message |
mark402001
Dodge Dakota
JOIN HERE
10/01/2015
10:39:26
|
 Subject: Modifications to exhaust and intake.
IP: Logged
Message:
I have a 95 3.9 several yrs ago I purchased some used exhaust manifolds that had the larger outlet. I am not sure what yr they are. I also purchased a used larger throttle body. I have rebuilt the motor it had a little over 260,000 miles on it and was so weak it would hardly pull an empty low boy trailer much less one loaded. Anyway I am trying to make some minor mods to the motor. I hear Ford injectors will interchange but not sure which ones. I found a piece of 1/4 inch aluminum plate and made the plate for the bottom of the intake to try and stop the gasket from leaking. Way back yonder when I was thinking and acquiring the parts for the mods I had read on one of these forums to cut back the runners in the intake. I said all this because I do not know what yr of y pipe to try and locate for the new/used manifolds or how much to trim off the intake runners inside the intake manifold and what yr Ford injectors to use. Any advice would be greatly appreciated.
|
?
Dodge Dakota
JOIN HERE
10/02/2015
04:56:20
| RE: Modifications to exhaust and intake.
IP: Logged
Message:
89 to 93 Mustang 5 liter
orange and black are the #19
Auto Zone does not list a o-ring kit for the
V6 but you can get a set for the 5.0 mustang
perfict fit
Always use a little oil on the rings
Bosch also has a lime green #19 with a 6 hole
spray pattern, I have alawys wanted to try these
but never got around to doing it posably even
more power and gas mileage
The FMS 4 hole work great in the dodge motors
smother running more power and better gas mileage
They give you better atomization
|
mark402001
Dodge Dakota
JOIN HERE
10/02/2015
09:40:59
| RE: Modifications to exhaust and intake.
IP: Logged
Message:
Thanks for the info on the injectors. Anyone know what yr Y-pipe will fit the older exhaust manifolds? I have the manifolds on but don't know what yr they are?
|
BarberAE
Dodge Dakota
JOIN HERE
10/08/2015
01:51:07
| RE: Modifications to exhaust and intake.
IP: Logged
Message:
The exhaust manifolds are most likely from a 92 or
93.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
