| From | Message |
ko
Dodge Dakota
JOIN HERE
4/17/2014
15:19:39
|
 Subject: backfiring v6
IP: Logged
Message:
My 92 3.9 Dakota backfires and sputters a lot.
I have to restart it over and over till it runs right.
The ring in the distributor is fine I checked that already.
All vacuum lines are good too.
Also when it starts up I know its not gonna run right because it will rev to 2k rpm & then die.
Any suggestions?
Someone told me the spark controller computer was the problem but idk.
|
joel wright
Dodge Dakota
JOIN HERE
4/18/2014
07:54:00
| RE: i have a code p1391
IP: Logged
Message:
I have a 1999 dodge dakota 3.9 liter with a scan
code p1391 truck runs fine for about 30 mins when
drive then try to stop at traffic light truck will
stall and takes a couple of mins to get it to start
again it's becoming a problem what should I do ????
|
daddio
Dodge Dakota
JOIN HERE
4/18/2014
08:52:35
| RE: backfiring v6
IP: Logged
Message:
That code P1391 could have a few causes. Bad cam or crank
sensor, worn distributor or distributor bushing. Worn timing
chain, bad or corroded connectors to the cam or crank sensor.
Check the connections first to make sure they are clean and
tight. Then check the sensors, if possible or replace them.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
