| From | Message |
Maxtouch
Dodge Dakota
JOIN HERE
10/20/2013
13:48:31
|
 Subject: 98 3.9 stalling
IP: Logged
Message:
have read several post for different years. Truck started stalling and losing power then stalling around 100 miles ago. No check engine light. Shop says had a crank sensor code stored. Replace same. Didn't even get out the parking lot before it stalled. Shop is trying to get it to do it again and it won't. I dont trust it. Does this year have the infamous line splice or not. Any input would be appreciated
|
Firebug
Dodge Dakota
JOIN HERE
10/23/2013
17:45:12
| RE: 98 3.9 stalling
IP: Logged
Message:
Take off your throttle body and clean it, put back on with new gasket. Clean your idle control located at the back of the throttle body.
No splice problem with this year.
"Drink a lot of beer after your done!"
|
Maxtouch
Dodge Dakota
JOIN HERE
10/24/2013
14:22:51
| RE: 98 3.9 stalling
IP: Logged
Message:
Thanks for the info. Turned out to be ECM.
|
Storman_07
Dodge Dakota
JOIN HERE
10/30/2013
19:35:16
| RE: 98 3.9 stalling
IP: Logged
Message:
Could either of you guy's help with this issue..... I have a 98 v6 3.9 sport..... new exhaust from the manifold right back, both sensors as well.... but the check engine light is still on and the code say's it's still the back sensor...... but both o2 sensor where just replaced!!!!!!! It has to pass an emission's test and I am right off the deep end with it!!!!!!!!!!!!! Can someone help??????
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
